Ultra Shield VS Halo Seat with Full Cover (as shown)

Made in the USA by American Craftsmen!!!

Get the full immersive oval racing feel at economical pricing, Ultra Shield's VS Halo Racing Seat.

The Ultra Shield VS Halo Racing Seat is constructed from .100" 5052 Grade Aluminum, with a .125" “Halo”. The “Halo” is reinforced with another piece of .125" Aluminum plate and is padded on back and sides with high impact absorbing foam. The VS Halo seat is available in sizes 14”-18”, in either 10º or 20º Layback. The VS Halo Race Seat is 15 inches deep. If you run long races and are looking for more leg support, we suggest the VS Long Bottom Halo Seat which is 20 inches deep...enqire

Full padded cloth cover included, you pick color. Full cover snaps into place and includes pieces that will cover the bottom and back of the seat as well as the rib supports, shoulder supports and halo.

Cover available in black, red, blue, grey, purple (+$20) or stripe (+$30). Stripe combo can be created from any of the above listed colors. Please indicate stripe combo in comments box during checkout.

Check out our VS Halo Measurement Charts for additional size information.

The Ultra Shield VS Halo Racing Seat Can be made 1" taller or 1" lower with double low ribs for no extra charge (allow additional time for custom construction). Drivers over 6'2" may want to consider 1" taller. Drivers over 6'4", please call us for custom seat suggestions.

Purple Covers, Stripe Covers, and 1" taller or lower are considered Special Order items and therefore are not returnable.

Purchase a seat with a ProChassis cockpit and save $100....enquire for details.

To determine your proper seat size you will need to take a measurement of your seated hip width.

To properly measure your "Seated Hip Width":

• Sit on a table or workbench.

• Place 2 rectangular objects (ex. 12 pack boxes or concrete blocks) against each hip. How tightly or loosely you place each box/block will determine the seat fit.

• Use carpenters square against table edge and boxes/blocks to ensure accurate measurement.

• Use metal tape to measure the inside measurement (across hips)of boxes/blocks.

For example, if inside measurement is 16 3/4 inches, we would suggest a 17 inch seat.